Local Furnace Repair Referral Service • 195 Mt Vernon Rd, Newark, OH 43055 24/7 Dispatch Line: (740) 616-1445

Furnace Igniter & Flame Sensor Repair in Newark, OH

Direct Answer: If your furnace clicks without lighting or ignites for 3–5 seconds and shuts right back off, you likely need hot-surface igniter or flame sensor repair in Newark, OH. Call (740) 616-1445 for fast component service.

What This Furnace Service Involves

Hot-surface igniters (silicon carbide or silicon nitride) are brittle heating elements that crack with thermal cycling, preventing burners from lighting. Flame sensors are thin metal rods that verify flame rectification in microamps; carbon buildup insulates the rod, causing the control board to cut gas flow within seconds as a safety precaution.

Common Warning Signs

  • Inducer fan runs, but no orange glow appears through the sight glass (failed igniter)
  • Burners ignite briefly for 3–5 seconds and immediately shut off (dirty or failed flame sensor)
  • Furnace cycles through three failed startup tries before entering 1-hour lockout

Our Referral & Diagnostic Process

  1. Call (740) 616-1445: Share your Newark or Licking County address and furnace symptom.
  2. On-Site Inspection: An independent local technician tests ignition, safety switches, airflow, and electrical draw.
  3. Upfront Quote & Repair: Review the written repair price before approving any part replacement.

Cost Factors in Newark, OH

Flame sensor cleaning or replacement is typically one of the most affordable furnace repairs in Ohio, while hot-surface igniters vary slightly by brand (Lennox, Carrier, Trane, Goodman).

Related Services & Local Coverage

Ignition faults are among the fastest same-day furnace repairs and a core part of gas furnace service. Technicians serve North End & Northtowne, Downtown Newark, and all of Newark, OH.

Frequently Asked Questions

A failed igniter keeps the burners from lighting at all, whereas a dirty or bad flame sensor allows the burners to light for a few seconds before shutting them down.

Lightly polishing a flame sensor with fine steel wool or a dollar bill is a common DIY step if you shut off power first, though technicians also measure microamp signal strength and check grounding.

Need Furnace Repair in Newark or Licking County?

Call now to be connected with an independent local heating technician for emergency no-heat diagnostics, ignition repairs, or airflow troubleshooting.

Call (740) 616-1445 Now
Call (740) 616-1445 — Newark Furnace Repair